East Point Heating and Air

I completed the installation of a new Rheem 4 ton air handler paired with a 3.5 ton air conditioning unit. The project involved installing a new return plenum equipped with a 20x20x1 filter to enhance air quality. Additionally, I installed a new emergency drain pan, a pan safety switch, a coil safety switch, a condensation pump, and a new thermostat to ensure optimal system performance. A composite pad was also installed for the outdoor unit. The supply plenum, high voltage, low voltage, drain line, and return duct were reconnected. After installation, I thoroughly tested the system operations and set the appropriate refrigerant charge to guarantee efficient and reliable performance.

Completed maintenance.

Arrived to system off and flashing code for pressure open. Removed pressure switch hose from inducer port and water started flowing out of inducer port. Water is backing up the drain line and into the inducer causing the inducer port to be clogged not allowing the pressure switch to close. Removed hose at the collector box and tried to blow through drain line. Went outside to check drain line and found that it had frozen not allowing the system to drain properly. Told homeowner that I could try and melt the ice with a hairdryer but more than likely it will freeze again. Other option is to install a condensation pump and run it to the vent stack, told him we would get the estimate sent over to him. Drain line is still clogged.

Arrived to outdoor fan blades rubbing against fan shroud. Removed condenser top and checked fan blades, blades aren’t damaged. Confirmed proper position of blades on motor shaft to make sure blades didn’t slip down. Properly secured fan shroud and tested fan. Fan blades are no longer making contact with shroud. If shroud continues to fall down will need to replace system however system is functioning properly at this time.

Performed single system Heat maintenance on furnace, replaced 16x25x1 filter. Furnace operating properly at this time

Quoted in hvacbizpro and emailed over

DCM1: Heat complete, replaced 16x20x4 filter. System is fully functional and operating within manufacturer specifications at this time. Refrigerant pressures and temperatures are appropriate for indoor and outdoor weather conditions. Maintenance checklist attached.

DCM1 : A/C complete, replaced (1) 16x25x1 filter. System is fully functional and operating within manufacturer specifications at this time. Refrigerant pressures and temperatures are appropriate for outdoor and indoor weather conditions. Photos and maintenance checklist attached.

Identified a clogged drain at evaporator pan outlet causing water to overflow the evaporator drain pan. Repaired and cleared drain line and searched for any other leak points. None identified.

Arrive No Cool Identified failed thermostat. Unable to make any adjustments to programming. Could not change the date or the time nor could you change the temperature setting. Thermostat is currently running the factory program.