Powder Springs Heating and Air Repair

We provided a comprehensive quote for a residential service, detailing all necessary tasks and associated costs. After the client reviewed and approved the quote, we sent it via email. Our team then executed the service, ensuring all work was completed to the highest standards. This included thorough cleaning, minor repairs, and maintenance tasks. We communicated regularly with the client to ensure satisfaction and address any concerns. The job was completed efficiently, leaving the client pleased with the results.

On Day 1, I removed outdated equipment and installed a new Rheem 5-ton evaporator coil, a 5-ton air conditioning unit, and an 80% efficient 100k BTU gas furnace. I also installed a new return plenum with a 20x25x1 filter, a supply plenum, an emergency drain pan, a pan safety switch, a coil safety switch, and a composite pad for the outdoor unit. I reconnected all necessary lines and tested the system in both heating and cooling modes, setting the appropriate refrigerant charge. On Day 2, I installed a new Mitsubishi 12k BTU heat pump mini-split, including new high voltage wiring, a breaker, disconnect, electrical whip, drain line, communication wire, and thermostat. I tested the system and set the refrigerant charge.

.

411

Addition Heat pump: HP outdoor condenser needs cleaned. Needs insulation on outdoor suction line Addition interior: supply grills mixed, 2&3 way grills. Drain pan rusted. 2 zone dampers inaccessible in knee wall space. Both working properly. May be accessible through back of closets but will have to cut Sheetrock out to do so. Zone board taped, face does not stay on well. Blower wheel needs cleaned. Heat checked and functioning. System low on refrigerant,410A. Refrigerant lines outside need re-insulated Main floor Furnace: Most supply registers 2 way. Screw in main drain line.heat checked and functional. System is Low on refrigerant, 410A. Blower wheel needs cleaned. Outdoor condenser needs cleaned Refrigerant lines outside need re-insulated Second floor Furnace: screw in main drain line. Furnace blower wheel needs cleaned. System low on refrigerant,410A. Outdoor condenser needs cleaned. Refrigerant lines outside need re-insulated Note:Estimate for refrigerant is appropriate

Removed faulty condenser variable speed motor, opened new motor and it is an indoor variable speed motor, will not work. Explained to home owner and informed office. Sent pictures of correct motor. Office needs to call customer.

Removed old equipment and installed new Rheem 3 ton heat pump, 3 ton evaporator coil with 80% gas furnace. Installed new return plenum with 16x25x4 filter, new emergency drain pan, new pan safety switch, new coil safety switch, new thermostat, new composite pad, and new line voltage monitor for outdoor unit. Reconnected supply plenum, high voltage, low voltage, drain line, gas line, vent pipe and return drop box. Tested system operations in heating and cooling, set refrigerant charge.

Completed single system cooling maintenance, replaced filters system operating properly at this time. The system is very old R22, talked with owner about replacing unit.

2020 Rheem Heat Pump has bad variable speed outdoor condenser motor. Needs replaced. Need to check warranty and give quote.

Completed cooling maintenance on 12 systems. Unit #4 has a bad contactor and a burnt wire. Unit is very old R22. Pictures of capacitor and wiring included. All other systems are operating as well as they can. All units are very old R22. They all need to be updated. All filters replaced.